Cordless Brushless Electric Impact Wrench and Screwdriver

Cordless Brushless Electric Impact Wrench and Screwdriver,

How to Use the Brushless Electric Wrench Impact Driver Cordless Electric Screwdriver Wrench

Step 1: Charging the Wrench

1. Before first use, make sure the battery is fully charged.
2. Connect the charger to a power source and plug it into the wrench’s charging port.
3. Wait for the battery to fully charge. The LED indicator on the charger will turn green when the charging is complete.
4. Disconnect the charger from the wrench.

Step 2: Installing Bits

1. Select the appropriate bit for your screw or bolt.
2. Insert the chosen bit into the hex chuck of the wrench.
3. Rotate the chuck clockwise until the bit is securely fastened in place.

Step 3: Adjusting Torque and Speed

The wrench allows for stepless speed changes and torque adjustments.

1. To adjust the torque, locate the torque adjustment ring on the wrench’s body.
2. Rotate the ring to the desired torque setting. Higher numbers indicate higher torque.
3. To adjust the speed, locate the speed change switch near the handle.
4. Slide the switch forward or backward to increase or decrease the speed respectively.

Step 4: Operating the Wrench

1. Hold the wrench firmly with both hands.
2. Position the bit on the screw or bolt you wish to tighten or loosen.
3. Press the trigger button located on the handle to start the wrench.
4. Release the trigger to stop the wrench.

Step 5: Utilizing LED Work Light

The wrench is equipped with a LED work light for better visibility in dark or confined spaces.

1. Before using the wrench in low-light environments, locate the LED work light button.
2. Press the button to turn on the LED work light.
3. Press the button again to turn off the LED work light.

, ,